/**************************************************************************************************
*
*  PIR Motion Sensor SE-90
*
*   Version:      1.0.0 - January 2009
*   Author:       Etienne Ribeiro    / tutorial assistant caad      /  eribeiro[at]ethz.ch
*   Supervisor:   Christoph Wartmann / chair for caad - ETH Zürich  /  wartmann[at].arch.ethz.ch
*
*   Desc:         Shows the use of an analog Accelerator. This Module can be used to plug severel
*                 Motion-Sensors to your project. Connect your sensors to any digital pin on your
*                 board.
*
***************************************************************************************************/




//
// Const

int digitalPin1 = 24; // Pin where PIR-Sensor's out pin is connected
int digitalPin2 = 32;


//
// Var

boolean initialized = false;


//
// Setup

void setup() {

        // LED (2 * blink)
        pinMode(48, OUTPUT);
        digitalWrite(48, HIGH);
        delay(200);
        digitalWrite(48, LOW);
        delay(200);
        digitalWrite(48, HIGH);


        // Start Serial
        Serial.begin(9600);


        // Append Motion Sensor
        //  You can append more Sensors if you want!
        MotionDetect_AppendSensor (digitalPin1);
        MotionDetect_AppendSensor (digitalPin2);

}




//
// Loop

void loop() {

        // if nothing moved during 3000 millis, sensor torns off and waits for next movement
        switch (MotionDetect_isSensorFiring (digitalPin1, 3000)) {

                case 1:

                Serial.println("Sensor1: Something moved...");
                break;

                case 0:

                Serial.println("Sensor1: ...and stopped.");
                break;

                case -1:

                break;

        }

        switch (MotionDetect_isSensorFiring (digitalPin2, 3000)) {

                case 1:

                Serial.println("Sensor2: Something moved...");
                break;

                case 0:

                Serial.println("Sensor2: ...and stopped.");
                break;

                case -1:

                break;

        }

        delay (200);

}